RouterBOARD = The hardware, physical device (specifically the motherboard) Long-Term v6.48.6 is also pre "Factory Software" which (as indicated below is v6.49). Some insight from trying to establish if a RBwAPG-5HacD2HnD (the new two port ARMv7(32) wAP ac, not previous one port MIPSBE wAP ac), which is sold factory new with RouterOS v6.49.6 (i.e Stable channel), can be downgraded to (currently) Long-Term v6.48.6 (as v6.49.6 is post that version). Note that if you feel corrections are needed then post them directly instead of snickering about the need, it's not like the manual has the complete clarified details. So there is a severe lack of comparables to clarify the subject (not specifically this topic), ideally accompanied by "screenshots" in correlation to commands.
On some models that is empty because this feature are added later. More than one partition with some differents RouterOS version and choose what boot at start and what boot for failover, if the current boot fail.Īny mix of version are possible, but no-one version can be older than Factory Software.įactory Software can be read on "system resources". I'ts possible to have on non-flash RouterOS (units non-smips and with more than 32MB of space and without /flash/ folder presence) There's not correlation with RouterOS version, it can be any not before factory RouterOS (software) versionĪfter RouterBOOT 3.42 / RouterOS 6.40.x all BIOS version number change with RouterOS version bundled, also if BIOS is exactly equal from previous version. There's no limit on firmware version, but it can be like factory version and up. fwf files or on bundle with current RouterOS (Upgrade Firmware). The current firmware is the only upgradable to any version with.
Is present (and fixed) If the factory version are 6.43.7 and up The Factory can be updated only for special event, like introduction of "protected routerboot" on previous model, and only on some board. 1) Factory Firmware (BIOS) is physically for recover device booting recovery BIOS, if for some reason main (current) BIOS are corrupted.Ģ) Current Firmware (BIOS) are the version loaded at the boot of RouterBOARD.
0 kommentar(er)
